From the gallery · free

Spanish Fighting Bull

medium difficulty · 19 pieces on 18 sheets.

maskerei.com

Rendered from the same 3D model the sheets are cut from.

How to build it

19 pieces. You need card, a craft knife, a steel ruler, an empty ballpoint and glue.

CutSolid line. The blade goes here.
Mountain foldFold away from you, printed side out.
Valley foldFold toward you, printed side in.
Eye panelCut it out and throw it away.
Glue tabGlue it under the edge with the same number.
  1. 1

    Print

    Print every sheet at 100 % on card between 160 and 220 gsm. Check the 5 cm line on sheet 1 with a ruler before you cut anything.

  2. 2

    Score the folds

    Before cutting, run an empty ballpoint along every dashed line, against a steel ruler. Scored card folds crisply; unscored card cracks.

  3. 3

    Cut out the pieces

    Cut along every solid line, around the glue tabs too. Keep the blade upright and cut toward you.

  4. 4

    Cut out the eye panels

    The small fine-dotted triangles are where your eyes go. Cut them out and throw them away.

  5. 5

    Fold

    Mountain folds away from you, valley folds toward you. Fold each one fully, then open it halfway.

  6. 6

    Glue, number to number

    Glue each tab under the edge that carries its number. Start at the nose and work outwards. Leave the chin and the back rim for last.

  7. 7

    Make it wearable

    Punch a hole on each side of the back rim and tie elastic through. Try it on before the glue sets, so you can ease any seam that pinches.